Installation & Commissioning of BTS Equipment

Scope of work:
  • Receipt of site information from customer along with TND/RND
  • RFI check along with ensuring the site permissions
  • Material reception at the sites and checking as per packing list. Intimate to the customer in case of any deficiency
  • Hoisting of GSM/CDMA antennas on tower as per TND/RND
  • Clamping and routing of RF cables from Shelter to Antennae
  • Grounding the Antennae and RF cables at appropriate place
  • Ensuring drip loop/Z loop at cable entry plate
  • Ensuring no sharp bend on RF cables
  • Fixing OGB
  • Weather proofing
  • Fixing EMPs/Surge arrestors along with connectorization in shelter
  • Grouting the BTS
  • Extending, power cables, E1 cables, grounding cables to BTS
  • Fixing IGB and extending grounding to all peripheral equipment
  • Fixing DDF
  • Installation of Battery bank and rectifier
  • Installation of internal cable try
  • Installation of indoor jumpers
  • Checking VSWR
  • Switching on the equipment
  • Commissioning the equipment as per defined procedure
  • Power measurement
  • Filling the check list and execution of quality audit

MW Installation and commissioning

Scope of works:

  • Receipt of site information from customer along with TND/RND
  • RFI check in near end and far end besides ensuring the site permissions
  • Material reception at both ends and checking as per packing list and intimate the customer in case of exigency
  • Assembling and hoisting of MW antennas & radios on tower in both ends as per TND/RND
  • Clamping and routing of if cables from Shelter to Antennae in both ends
  • Grounding the antennas and RF cables at appropriate place
  • Fixing Transmission rack if required in both ends
  • Installation & commissioning of IDUs in shelters
  • Alignment of MW antennas till we achieve required receive level
  • Grounding, weather proofing and labeling all cables in both ends
  • Acceptance test
 
BSC/MSC/STP/SDH/DWDM/PTN/XDM/DLC/FSO/DSLAM Installation and commissioning

Scope of works:
  • Receipt of site information from customer along with TND/RND
  • RFI check at the site besides ensuring the site permissions. Sending the SDR to customer
  • Material reception and checking as per packing list and intimate the customer in case of exigency
  • Grouting the equipment rack and inserting all required modules as per the manual/lay out drawing
  • Interconnection with appropriate cables/jumpers
  • Grounding the equipment
  • Installation of DCDB and extension of power to the equipment
  • Installation of DDF and extension of E1s to the equipment by Kroning
  • Installation of optical cables if required and measurement of power
  • Switching on the equipment and commissioning as per the procedure
  • Allotment of given IP address and extension of services to the subscribers
  • BER test if required
  • Preparation of AT document and sign off
 
  © 2013 Aster Private Limited. All Rights Reserved. Sitemap |  Privacy Policy